CAB A8+ Návod k obsluze stáhnout pdf (Strana 104)

B-6 cab Produkttechnik GmbH & Co KG

Error message

Protocol error (*)

Read error

ROM malfunction

Structural error

Unknown card

Voltage error

Write error

Wrong revision

Solution

Depending on the type of error, the

command can be skipped by

pressing the key or the print

job must be canceled by pressing

the key.

Switch the printer off.

Correct the interface settings in

printer setup (see chapter 8).

Check the data on the memory card.

Save the data to another card and

reformat the original card.

Switch printer off, then on again.

If error reoccurs, contact Service.

Format the memory card.

Format the memory card. Use the

correct type of card as specified in

the Memory Card section.

Switch printer off, then on again.

If error reoccurs, contact Service.

Please note the voltage error

displayed to Service personnel!

Repeat the write process or reformat

the memory card.

Load a valid firmware version.

Possible cause

Printer has received an unknown or

invalid command (display shows

command abbreviated).

The interface of the computer and

printer are set differently.

Error when reading from the

optional memory card.

Hardware error

The optional memory card file

structure is not compatible.

The optional memory card is not

formatted, or is not the type

supported by printer.

Hardware error

The optional memory card has

encountered a hardware error.

Error during a firmware update.

Firmware version is not valid for the

present hardware version.

Table B-3 Error Messages (continued)

Appendix B - Error Messages / Problem Solution

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 119 120

Komentáře k této Příručce

Žádné komentáře